There are no comments up to now.
| 1971 Olds "S71" Rear Sheetmetal Removal |
|
 Sparks are flying as we cut into the rear section of the 1971 Oldsmobile "S71" project. We began by drilling spotwelds, then using an HTP plasma cutter to remove the large sections of unwanted steel in the wheelhouse and trunk floor areas. Then, it was more spotweld drilling and seperating to clean the remaining flanges. This is the dirty work.
SOURCES
Share this link on your favorite social network!
         
» No Comments
» Post Comment
Only registered users can write a comment.
Please login or register. |
| < Prev | Next > |
|---|
