The last step in our GTO's Air Ride Technologies Street Challenge suspension system was to install the ride height sensors and Air Pod unit, and connect the wiring to the LevelPRO control unit in the dash.   The system takes ride height inputs from the 4 sensors mounted around the car, then the Air Pod combination compressor / solenoid / tank / power unit sends the correct amount of air pressure to each airspring to keep the car level and at its user pre-set ride height.    The system is very high tech, but it's simple to install. 

Discuss this project in the V8TV Forum! 

SOURCES

Air Ride Technologies

DISCLAIMER: Demonstrations and procedures contained in the V8TV show or website may not provide all necessary or relevant information. Applicable local laws and regulations may vary and should be checked before any project is commenced. Be sure to follow all applicable safety procedures. V8TV Productions, Inc. makes no warranties, expressed or implied, as to the completeness, accuracy, or practicality of any such demonstration or procedure or any information with respect thereto contained in the preceding program. C. 2009, V8TV Productions, Inc.  

Share this link on your favorite social network!