Once the Standox Sprayable Polyester was block sanded to a 220 grit surface, body tech John Blandford prepped our 1965 Chevelle's body for a couple coats of DuPont Hot Prime primer.   The Hot Prime is part of the Hot Hues line, and provides the last sandable layer before final sealer and then color.   John sprayed the primer using a SATA KLC spraygun and the 3M PPS cup system.   The KLC HVLP low overspray primer and filler gun for its ability to finely atomize heavier materials reducing the amount of sanding needed for a flat surface, and the PPS cup system makes clean-up simple with less solvent waste.  The next chapter in the '65 Chevelle story... spraying the color! 

SOURCES

DuPont Hot Hues

3M

SATA

DISCLAIMER: Demonstrations and procedures contained in the V8TV show or website may not provide all necessary or relevant information. Applicable local laws and regulations may vary and should be checked before any project is commenced. Be sure to follow all applicable safety procedures. V8TV Productions, Inc. makes no warranties, expressed or implied, as to the completeness, accuracy, or practicality of any such demonstration or procedure or any information with respect thereto contained in the preceding program. c. 2010, V8TV Productions, Inc.

Share this link on your favorite social network!